|
Permits mounting of closed hole Mazda and Hyundai, Subaru, Champ and Colt rotors.
|
Designed for mounting small splined drums and rotors such as Focus or VW.
|
|
Designed for 2004 + Ford Trucks
F-150’s with 6-7 Lug pattern. Fits on any 1” Arbor.
|
For mounting Flywheels with center-holes too small for the standard 1" arbor (433701). Recommended for Hyundai and Honda mountings.
|
|
For any type of sealed and/or pressed in bearings on Drums or Rotors.
Perfect for Ford Probe, Toyota Van, Renault Alliance and others.
|
For mounting Heavy-Duty Truck hubbed and hubless drums, rotors, or flywheels.
Fits all 1-7/8” Arbors ( any brand lathe) can also be mounted on any 1” Arbor when combined with # 434472 Step down Adapter Set
|
|
Designed for mounting larger hubbed drums and rotors.
Fits all 1” Arbors (any brand lathe)
|
Designed for mounting hubbed truck drums and rotors.
|
|
For Small Rotors, Drums, and Flywheels.
Fits all 1” Arbors (any brand lathe)
|
Designed for Composite Rotors and Hubless Rotors
Fits all 1” Arbors (any brand lathe)
|
|
1” (25 mm) x 12” (2" longer)
For use with deeper profile drums, rotors or flywheels that require mounting further out on arbor to prevent contact with lathe housing.
* Shown with 433713 Arbor Nut sold separately.
|
For center-holes with less than one inch inside diameter.
Some applications are: Honda, Datsun, Toyota, many imports, and many domestics. Also handles splined hubbed rotors and drums.
|
|
1-7/8” (48 mm) x 18”
For Truck – Bus – RV applications. Handles both hubbed and Hubless truck drums, rotors and flywheels above 350 series.
|
1-7/8” (48 mm) x 22”
Increases weight capacity to 600 lbs. Use with 8989 series lathe using 434465 HD Adapter Set. Applications include mounting dual wheels and tire assemblies.
|
|
Chuck Adapter for Starter and Generator Armatures, Transmission Drums, etc.
Provides adaptation to a diversity of special applications.
*Requires ¾” capacity, # 3 Jacobs taper mounting chuck, which may be purchased locally.
|
Unique, versatile adapter which allows mounting of large center-holed flywheels and rotors (5.25"-7.5") such as VW, Omni, Horizon, etc…
For 1" Arbor. Includes two sets of jaws.
|
|
Used for mounting heavy-duty hubless truck drums and rotors and any other items to be machined which have large center-holes (7.75" to 13.5").
1-7/8" arbor and outboard support are required (434466).
|
|
|
